Standard Resin Gray 0.5Kg UV 405nm eSun

This affordable standard Resin from Esun offers superb cost-effectiveness with good print quality. This standard UV-Photopolymer resin contains methacrylic monomers to reduce volume shrinkage during the light curing process, hence 3D printed objects of incredible fine detail are possible. The Resin is compatible with most DLP and LCD 3D printers. eSun is one of the largest manufacturers of high-quality resin used for 3D printing.

Recommended accessories:

Latex Protective Gloves L 100 Pack
Creality Resin Filter 20 Piece
1 Liter Isopropyl Alcohol / Isopropanol 99.8%

Properties of Standard Resin:

Best value for money among all resins for DLP and LCD printers.
Low volume shrinkage as the resin is supplemented with methacrylic monomers.
Specifically designed for LCD/LED SLA printers, to achieve the best print quality.
The resin is compatible with all LCD printers with 405nm wavelength.
High hardness and scratch resistance of 78-82D (Shore).
Faster print speed.
High precision when printing.
Very good moisture resistance.
Long durability as the resin is delivered in light-proof aluminium bottles.

Application, important information:

Shake before use. Not too hard, so that no air bubbles form. Avoid direct sunlight during application.
Keep the resin out of reach of children.
Wear gloves before use, to avoid direct contact with the skin.
Ventilate the room well.
In case of accidental contact with the skin: wash immediately with plenty of water.
Printed models must be cleaned with high-concentration alcohol (>95%) for approximately 30 seconds.