Gravity MOSFET Driver Module 10A

With the Gravity MOSFET driver module, you can control large currents up to 20A with your microcontroller or Raspberry Pi. You can control the module like a relay but also with PWM. The module supports a logic level when switching from 3.3V to 10V. Thus, the module can be used universally. The VIN connector supports 5 to 36V DC and 0 to 20A current input. If the current is over 10A, we recommend installing an external heat sink. The MOSFET can be used up to a switching frequency of 1KHz. 

Info: The MOSFET power controller has a PH2.0-3P Gravity connector. You can reverse the supplied connector by attaching a Dupont Cable M-M 10cm to male. That way, you can use it on an Arduino UNO too.

Documentation:

• DFRobot Wiki

Arduino Connection Example:

Technical Details: 

• VIN Operating voltage: 5V-36V DC
• VIN Operating current: 0A-20A (an external heat sink is recommended for a current over 10A)
• Logic Level Voltage: 3.3 to 10V DC
• Switching frequency: 0-1KHz
• Switching behavior: T(on)=20us/T(off)=50us
• Operating temperature: -55°C to 155°C
• Interface type: PH2.0-3P
• Dimensions: 44 x 32 x 15mm
• Weight: 21g

Scope of delivery:

• 1x Gravity MOSFET driver module 10A
• 1x Gravity 3pin digital sensor cable PH2.0 to XH2.54