eResin-PMMA Like Transparent 0.5Kg UV 405nm eSun

This is a 405nm UV resin from eSun with a transparent look similar to PMMA. Thanks to a new formula that hardly yellows, the resin looks like transparent acrylic after printing. This makes it perfect for model building or mechanical applications, but also for aesthetic appeal. 

Recommended Accessories:

• Nitril Gloves L 100 Pack
• Creality Resin Filter 20 Pieces
• 1 Litre Isopropanol / Isopropanol 99.8%

Properties: 

• Transparent, like PMMA acrylic glass
• Almost no yellowing
• Suitable for model building, mechanical applications such as headlight lenses

Application, Important Information: 

• Shake before use. Not too hard, to prevent air bubbles. Avoid direct sunlight during application. 
• Keep the resin away from children. 
• Wear gloves before use to avoid direct skin contact. 
• Ventilate the room well. 
• If accidentally contacting the skin, wash immediately with plenty of water. 
• Models must be cleaned with high-concentration alcohol (>95%) for about 30 seconds after printing. 
• If the curing time is too long, the resin may slightly yellow. To eliminate yellowing, soak the resin in hot water for 30 seconds and then put it in the microwave for 30 seconds. 
• After printing and curing, for best results, the resin should be polished with 400-800 grit sandpaper. 

Download: 

• Technical Data Sheet eResin-PMMA
• Safety Data Sheet eResin-PMMA

Technical Details: 

• Manufacturer: eSun
• Type: eResin-PMMA Like
• Manufacturer SKU: ERESINPMMA PM200-T05
• Colour: Transparent
• Viscosity: 300mPa*s
• Density: 1.05-1.15g/cm3
• Tensile Strength: 58MPa
• Elongation at Break: 10%
• Flexural Strength: 30MPa
• Impact Resistance: 15J/m
• Hardness (Shore D): 70
• Resin Weight: 500g

Delivery: 

• 1x eResin-PMMA Like Transparent 0.5Kg UV 405nm eSun