5-30V Dual MOSFET Trigger Time Relay Module

With this MOSFET timer relay, you can set a delay from 0.1sec to 999min before the module turns on or off. The input voltage is 5-30V and the trigger voltage is 3-24V. The module has an LED display and 4 buttons, which you can use to set the delay and other modes. The module has polarity protection.  

User Manual:  

• The module has 4 buttons: STOP, SET, UP and DOWN. The STOP button can turn the whole module on or off. By using the SET, UP and DOWN buttons, you can switch between different modes and set the delay time.  
• After connecting the supply voltage, you must press the SET button for 2 seconds to switch to mode selection. There are a total of 4 different modes, P1, P2, P3 and P4, which are then subdivided into subcategories P1.1, P1.2, P1.3, P3.1, etc. With UP and DOWN, you switch between the modes.  
• Once you have found the desired mode, press SET again to set the time. You set the time with Up and Down, you change the decimal place with STOP.  
• After setting the time or times (depending on the mode), press SET again for 2 seconds, then release and wait until the display shows 000. Then the module is ready for operation. 

Mode List: 

• P1: The module switches ON as soon as the trigger signal is detected and remains ON for the set "OP" time. If a trigger signal is detected again during the ON time, depending on the mode, the following happens: 
• P1.1: nothing, the time continues to run down and then the module switches off until it is triggered again. 
• P1.2: The time is restarted and runs again from the beginning. 
• P1.3: The module switches off. 
• P2: After the trigger signal, the set "CL" time expires before the module switches ON for the set "OP" time and then switches off again. 
• P3.1: After the trigger signal, the module switches ON for the set "OP" time. After the "OP" time has expired, the module switches off again until the set "CL" time has expired. This cycle is then repeated for the set "LOP" value. If a signal is detected again while the "CL" time is running, the whole thing starts from the beginning.  
• P3.2: In this mode, everything from P3.1 happens without requiring a trigger signal. 
• P4: As long as a trigger signal is present, the module remains switched ON. As soon as the signal is gone, the "OP" time begins to run down and then switches off. 

Technical Details: 

• Input voltage: 5-30V 
  
• Trigger voltage: 3-24V 
  
• Type: Dual MOSFET Trigger- Timer Relay 
  
• Mounting hole diameter: 3.1mm 
  
• Hole spacing: 28.5 x 54mm 
  
• Dimensions: 60 x 34.5 x 12mm 
  
• Weight: 17g

Scope of Delivery:  

• 1x 5-30V Dual MOSFET Trigger Timer Relay Module