CCS811+BME280 CO2 Air Quality Environmental Sensor

This CCS811 air quality sensor from DFRobot can measure the density of eCO2 (CO2 equivalent) and TVOC (Total Volatile Organic Compounds). Additionally, a BME280 sensor is present on the board, allowing you to measure temperature, air pressure, and humidity. It can be used in many applications, such as air quality detection, air purifiers, ventilation systems, etc. This CCS811 air quality sensor uses AMS's unique micro-hotplate technology. Compared to traditional gas sensors, the heating wire has lower power consumption, heats faster, and is smaller. A small MCU is installed on the board for evaluation, where you can easily read the measurement data via I2C. The CCS811 supports a concentration alarm that is triggered when the concentration exceeds the threshold set by the user. The CCS811 air quality sensor supports multiple operation modes, such as the 5 types of measurements: every second, every 10s, every minute, every 250ms, and a sleep mode. These modes are optimized for low power consumption during sensor measurement, making the CCS811 also suitable for portable battery-powered applications.

NOTE: The chip has a special I2C clock. Therefore, it is incompatible with some controllers, such as Raspberry Pi.

Due to a chip shortage, the CCS811 chip will be temporarily replaced by a ScioSense ENS160. (this is important for ESPHome, as the ENS160 is not yet supported.)

Features:

Short warm-up time
Low power consumption
Highly integrated MCUs and ADCs
IAQ threshold alarm
Capable of measuring CO2, temperature, humidity, and air pressure

Applications for CCS811 and BME280

Air quality detection in cars
Indoor air quality detection
Air purifiers
Ventilation system
COVID 19 warning light

Documentation:

Technical Details:

Operating Voltage: 3.3V to 5.5V
Operating Current: <20mA
Interface: I2C
CCS811:

Sleep current consumption: 0.7uA
I2C Address: 0x5A (Default) / 0x5B
TVOC measurement range: 0 to 1100ppb (Parts per Billion)
eCO2 measurement range: 400 to 8000ppm (Parts per Million)
Operating mode: 5 different modes

BME280:

I2C Address: 0x76 (Default) / 0x77
Operating temperature: -40°C to 85°C
Temperature measurement range: -40°C to 85°C, resolution of 0.1°C, deviation of +-0.5°C
Humidity measurement range: 0 to 100%RH, resolution of 0.1%RH, deviation of +-2%RH
Pressure measurement range: 300 to 1100hPa

Dimensions: 20 x 28 x 8.5mm
Weight: 8.5g